Coatings for Tubular Steel Structures Protection

Extending the Service Life of Galvanized Steel Poles - 314.664.2230

• 100% solids, Zero VOC
• High impact and abrasion resistance
• Direct to Prepared Galvanized Steel
• Unlimited film builds with a single pass
• Low Temperature Cure

To request general information or for any questions, please Contact Chemline and a representative will respond shortly.

CHEMTHANE 2260 is a solvent free, two component polyurethane protective coating (1:1 ratio by volume). This product has a very short reaction time and is therefore spray applied using plural component spray equipment. Application of this product is made directly to surface prepared steel. Primers are not necessary. Unlimited film builds may be achieved in a single coat multi-pass application. Cured films are free of pores.  This coating cures to form a hard polymer film that demonstrates excellent adhesion, abrasion resistance, chemical resistance and high mechanical strength. Cured films that are between 18 and 30 mils (0.5 - 0.75mm) in thickness will provide permanent and fully effective corrosion protection for many years.

• 100% solids/Zero VOC
• 1:1 mix ratio
• Cures to the touch in about 3-5 minutes
• 1800+ adhesion to steel
• 76 Shore A hardness
• 5600+ psi tensile strength
• Excellent abrasion resistance

CHEMTHANE 3700 is a solvent free, two component polyurethane protective corrosion coating (1:1 spray ratio by volume). This product has a very short reaction time and is therefore spray-applied using plural component spray equipment. This product is applied as a thin film topcoat over CHEMTHANE 2261 or equivalent.  CHEMTHANE 3700 cures to form a hard polymer film that demonstrates excellent resistance to ultra-violet light, abrasion and chemical attack. It is used in applications that require UV resistance and high production rates.

• 100% solids/Zero VOC
• 1:1 mix ratio
• Aliphatic / UV stable coating
• Applied wet-on-wet to CHEMTHANE 2260
• 70 Shore A hardness
• 4700+ psi tensile strength
• >60 in lbs impact resistance

CHEMLINER 4000 is a high solids, novolac epoxy lining. This product is self-priming and is applied to steel surfaces. It has excellent chemical resistance against jet fuel, wastewater, seawater, salt brine, sulfide gas, acid solutions, strong alkali solutions and many solvents. The high cross-link density of the product makes it suitable for immersion service in aggressive environments. Consult CHEMLINE before specifying. CHEMLINER 4000 is easy to apply using a brush, roller, conventional or airless spray equipment. This product is applied in a minimum of two coats (white coat and gray coat).

• High solids (73% by volume)
• 4:1 mix ratio
• Two coat application
• High chemical resistance for aggressive immersion environments
• Excellent adhesion to steel

To request general information or for any questions, please Contact Chemline and a representative will respond shortly.